zoukankan      html  css  js  c++  java
  • Zynq ZC706 传统方式移植Linux -- 编译u-boot

    我用的是zc706不是zed

    基本思路是:

    1.安装交叉编译工具(见  https://www.cnblogs.com/idyllcheung/p/10532654.html

    2.下载xilinx uboot源码 git clone https://github.com/xilinx/u-boot-xlnx.git

    3.编译

    make zynq_zc706_defconfig

    make CROSS_COMPILE=arm-xilinx-linux-gnueabi-

    出现如下错误:

    *** Your GCC is older than 6.0 and is not supported
    arch/arm/config.mk:66: recipe for target 'checkgcc6' failed
    make: *** [checkgcc6] Error 1

    修改以下部分:

    vim ./arch/arm/config.mk

    64行左右:

    ############# old ##############

    else
    archprepare: checkgcc6
    endif

    checkgcc6:
        @if test "$(call cc-name)" = "gcc" -a
                "$(call cc-version)" -lt "0600"; then
            echo '*** Your GCC is older than 6.0 and is not supported';
            false;
        fi
    ############# old ##############

    改为:

    ########### new ###############
    #else
    #archprepare: checkgcc6
    endif

    #checkgcc6:
    #    @if test "$(call cc-name)" = "gcc" -a
    #            "$(call cc-version)" -lt "0600"; then
    #        echo '*** Your GCC is older than 6.0 and is not supported';
    #        false;
    #    fi
    ########### new ###############

    就是将checkgcc6目标去除,和交叉编译器版本有关

    make CROSS_COMPILE=arm-xilinx-linux-gnueabi-

    将u-boot.elf拷贝出来,并不是u-boot

    然后在sdk中生成BOOT.bin(BOOT.bin可以直接烧到qspi中,不需要BOOT.mcs

    从SDK中将上述fsbl.elf、硬件的.bit文件、u-boot.elf打包成BOOT.bin。

    拷贝到sd卡里,将启动方式设置为sd卡启动,上电后就可以看到u-boot命令行,hooray,恭喜自己吧。

  • 相关阅读:
    基于FPGA的ARP协议实现
    Modelsim 仿真错误集锦
    基于FPGA的IIC驱动设计
    状态机跑飞的解决办法
    基于FPGA的检测时钟脉冲的高电平及低电平的中点标志位设计
    基于FPGA的UART实现
    基于FPGA的数字秒表设计
    Matlab的常用调试方法
    基于FPGA的花样流水灯
    **time_limited.sof文件
  • 原文地址:https://www.cnblogs.com/idyllcheung/p/10535072.html
Copyright © 2011-2022 走看看