zoukankan      html  css  js  c++  java
  • 思科、华为交换机链路聚合(LACP)配置实例

    思科:3560G
    华为:S5300

    思科G0/25---华为G0/0/1
    思科G0/27---华为G0/0/2

    华为交换机配置链路聚合有两种模式,分别是manual和lacp-static,如果不做配置,交换机默认是manual,所以一定要手动将模式改为lacp-static,这点很重要,否则无法跟思科交换机成功协商LACP。

    华为交换机
    #interface Eth-Trunk1
     port link-type trunk
     port trunk allow-pass vlan 2 to 4094
     mode lacp-static    //修改链路聚合模式
     max active-linknumber 2   //设置最大活动链接数为2
     bpdu enable        //开启BPDU

    #lacp priority 100

    #interface GigabitEthernet0/0/1
     eth-trunk 1
     undo ntdp enable
     undo ndp enable
    (在配置端口前,一定要将端口原有配置清空,全部undo掉,否则无法应用eth-trunk命令。如果之前端口配置过trunk口,可以使用undo port link-type清除trunk状态)

    #interface GigabitEthernet0/0/2
     eth-trunk 1
     undo ntdp enable
     undo ndp enable

    思科交换机
    interface port-channel1
     switchport trunk encapsulation dot1q
     switchport mode trunk

    interface g0/25
    switchport trunk encapsulation dot1q
    switchport mode trunk
    channel-group 1 mode active

    interface g0/27 
    switchport trunk encapsulation dot1q
    switchport mode trunk
    channel-group 1 mode active

  • 相关阅读:
    Qt之镜像旋转
    Qt之QCheckBox
    Qt之动画框架
    Qt之QFileSystemWatcher
    Qt之qSetMessagePattern
    Qt之qInstallMessageHandler(重定向至文件)
    Qt之qInstallMessageHandler(输出详细日志)
    Qt之窗体透明
    Qt之窗体拖拽、自适应分辨率、自适应大小
    Qt之设置应用程序图标
  • 原文地址:https://www.cnblogs.com/surplus/p/15621201.html
Copyright © 2011-2022 走看看