2019 SDN上机第2次作业
1. 利用mininet创建如下拓扑，要求拓扑支持OpenFlow 1.3协议，主机名、交换机名以及端口对应正确，请给出拓扑Mininet执行结果，展示端口连接情况
创建拓扑
2. 直接在Open vSwitch下发流表，用vlan得到下列虚拟网段，请逐条说明所下发的流表含义
将h1,h2,h3进入s1的包打上vlan tag，转发端口4
sudo ovs-ofctl -O OpenFlow13 add-flow s1 priority=1,in_port=1,actions=push_vlan:0x8100,set_field:4096->vlan_vid,output:4
sudo ovs-ofctl -O OpenFlow13 add-flow s1 priority=1,in_port=2,actions=push_vlan:0x8100,set_field:4097->vlan_vid,output:4
sudo ovs-ofctl -O OpenFlow13 add-flow s1 priority=1,in_port=3,actions=push_vlan:0x8100,set_field:4098->vlan_vid,output:4
将从端口4的包去除vlan tag， 并根据tag进行转发
sudo ovs-ofctl -O OpenFlow13 add-flow s1 priority=1,dl_vlan=0,actions=pop_vlan,output:1
sudo ovs-ofctl -O OpenFlow13 add-flow s1 priority=1,dl_vlan=1,actions=pop_vlan,output:2
sudo ovs-ofctl -O OpenFlow13 add-flow s1 priority=1,dl_vlan=2,actions=pop_vlan,output:3
将h4,h5,h6进入s2的包打上vlan tag，转发端口4
sudo ovs-ofctl -O OpenFlow13 add-flow s2 priority=1,in_port=1,actions=push_vlan:0x8100,set_field:4096->vlan_vid,output:4
sudo ovs-ofctl -O OpenFlow13 add-flow s2 priority=1,in_port=2,actions=push_vlan:0x8100,set_field:4097->vlan_vid,output:4
sudo ovs-ofctl -O OpenFlow13 add-flow s2 priority=1,in_port=3,actions=push_vlan:0x8100,set_field:4098->vlan_vid,output:4
将从端口4的包去除vlan tag， 并根据tag进行转发
sudo ovs-ofctl -O OpenFlow13 add-flow s2 priority=1,dl_vlan=0,actions=pop_vlan,output:1
sudo ovs-ofctl -O OpenFlow13 add-flow s2 priority=1,dl_vlan=1,actions=pop_vlan,output:2
sudo ovs-ofctl -O OpenFlow13 add-flow s2 priority=1,dl_vlan=2,actions=pop_vlan,output:3
3. 直接在Open vSwitch查看流表，提交OVS命令执行结果
s1：
s2：
4. 提交主机连通性测试结果，验证流表的有效性
再次输入pingall命令查看连通性测试结果，由上图可知
h3和h6互通
h1和h4互通
h2和h5互通
其余主机不通，流表有效
5.利用Wireshark抓包，分析验证特定报文
