【知识点】
|
linux命令： df fdisk mount/unmount |
【步骤】
1. 查看磁盘信息 fdisk -l
[root@host-10-14-40-177 dev]# fdisk -l
Disk /dev/vda: 4294 MB, 4294967296 bytes
43 heads, 32 sectors/track, 6096 cylinders
Units = cylinders of 1376 * 512 = 704512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disk identifier: 0x000dcf96
Device Boot Start End Blocks Id System
/dev/vda1 * 2 6097 4193280 83 Linux
Disk /dev/vdb: 2147.5 GB, 2147483648000 bytes
16 heads, 63 sectors/track, 4161015 cylinders
Units = cylinders of 1008 * 512 = 516096 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disk identifier: 0xb29abbe6
Device Boot Start End Blocks Id System
/dev/vdb1 1 208052 104858176+ 83 Linux
/dev/vdb2 208053 2288561 1048576536 83 Linux
2. 添加分区 fdisk 磁盘
fdisk /dev/vdb #在磁盘/dev/vdb划分磁盘
[root@host-10-14-40-177 dev]# fdisk /dev/vdb
WARNING: DOS-compatible mode is deprecated. It's strongly recommended to
switch off the mode (command 'c') and change display units to
sectors (command 'u').
Command (m for help): n #添加分区
Command action
e extended
p primary partition (1-4)
p #添加主分区
Partition number (1-4): 3
First cylinder (2288562-4161015, default 2288562):
Using default value 2288562
Last cylinder, +cylinders or +size{K,M,G} (2288562-4161015, default 4161015): +50G
Command (m for help): w #写入分区
The partition table has been altered!
Calling ioctl() to re-read partition table.
Syncing disks.
3. 格式化磁盘
mkfs.exts4 /dev/vdb3
备注：格式分区方法
|
mkfs - 支持ext2、ext3(日志)、vfat、msdos、jfs、reiserfs等 用法1：mkfs -t <fstype> <partition> 例：#mkfs -t ext3 /dev/hda1 用法2：mkfs.<fstype> <partition> 例：#mkfs.vfat /dev/hda2 |
4. 挂载分区
mount /dev/vdb3 /home
5. 写入/etc/fstab文件
以上操作，在系统重启后，swap文件的大小又会变回原大小，我们可以在/etc/fstab里增加下面的配置，使其重启后，我们刚刚的配置仍然有效。添加如下：
|
/dev/vdb1 /u01 ext4 defaults 0 0 /dev/vdb2 /data ext4 defaults 0 0 /dev/vdb3 /home ext4 defaults 0 0 /dev/vdb4 swap swap defaults 0 0 |