ti8168 eth0 启动

ti8168 原始文件系统进去后没有网络eth0接口，为了有该接口须要配置/etc/network/interfaces 文件

详细配置例如以下(红色要配置)

# /etc/network/interfaces -- configuration file for ifup(8), ifdown(8)
 
# The loopback interface
auto lo
iface lo inet loopback

# Wireless interfaces
#
# Example of an unencrypted (no WEP or WPA) wireless connection
# that connects to any available access point:
#
iface wlan0 inet dhcp
        wireless_mode managed
        wireless_essid any
#
#
# Same as above but locked to a specific access point:
#
#iface wlan0 inet dhcp 
#       wireless_mode managed
#       wireless-essid some-essid
#
# A WEP encrypted connection locked to a specific access point:
#
#iface wlan0 inet dhcp 
#       wireless-essid some-essid
#       wireless-key s:My-PlainText-Password
#       wireless-mode managed                 
#
# A WPA1 or WPA2 encrypted connection locked to a specific access point.
# This is the best option for non-roaming, single-network usage.
# Note that your card may require a firmware update to use WPA.
# Some distributions install a temporary volatile firmware update on ifup.
#
#iface wlan0 inet dhcp                                                  
#       wpa-essid some-essid                                         
#       wpa-psk My-PlainText-Password                                             
#
# A WPA1 or WPA2 encrypted connection using an external configuration file
# for wpa-supplicant. This is the way to go if you need to configure multiple
# networks with different keys and / or WPA settings and roaming support.
#
# iface wlan0 inet dhcp
#    wpa-conf /etc/wpa_supplicant.conf
#    wpa-driver hostap

iface atml0 inet dhcp

# Wired or wireless interfaces
auto eth0
iface eth0 inet dhcp
        pre-up /bin/grep -v -e "ip=[0-9]+.[0-9]+.[0-9]+.[0-9]+" /proc/cmdline > /dev/null

iface eth1 inet dhcp

# Ethernet/RNDIS gadget (g_ether)
# ... or on host side, usbnet and random hwaddr
iface usb0 inet static
        address 192.168.0.202
        netmask 255.255.255.0
        network 192.168.0.0
        gateway 192.168.0.200

# Zaurus 2.4 Lineo net_fd; obsolete
iface usbd0 inet static
        address 192.168.129.201
        netmask 255.255.255.0
        network 192.168.129.0
        gateway 192.168.129.200

# iPAQ 2.4 mach-sa1100/usb-eth
# (192.168.0.202 is the iPAQ's IP, 192.168.0.200 is the host's IP)
iface usbf inet static
        address 192.168.0.202
        netmask 255.255.255.0
        network 192.168.0.0
        gateway 192.168.0.200

# Bluetooth networking
iface bnep0 inet dhcp

 

ifconfig eth0 MTU 9000