zoukankan      html  css  js  c++  java
  • SPI 1

    SPI is a simple interface that allows one chip to communicate with one or more other chips.

    How does it look?

    Let's start with a simple example where only two chips have to communicate together.

    SPI requires 4 wires to be used in between the two chips.

    As you can see, the wires are called SCK, MOSI, MISO and SSEL, and one of the chip is called the SPI master, while the other the SPI slave.

    SPI fundamentals

    Basically:

    1. It is synchronous.
    2. It is full-duplex serial.
    3. It is not plug-and-play.
    4. There is one (and only one) master, and one (or more) slaves.

    In more details:

    1. Synchronous: a clock is generated by the master.
    2. Full-duplex serial: data is serialized, one bit of data is transferred in each direction during each clock period, so two data wires are used (MOSI and MISO).
    3. Not plug-and-play: The master and slave know beforehand the details of the communication (bit order, length of data words exchanged, etc...).
    4. One master: slave(s) cannot initiates communication, only the master can. The slave(s) listen and respond.
    Simple transfer

    Let's assume that the master and slave expect 8-bits data transfers, with MSB transmitted first.
    Here's how would look a single 8-bits data transfer.

    The line MOSI is the "master output" while MISO is the "slave output". Since SPI is full-duplex, both lines toggles simultaneously, with different data going from master-to-slave, and slave-to-master.

    In more details:

    1. The master pulls SSEL down to indicate to the slave that communication is starting (SSEL is active low).
    2. The master toggles the clock eight times and sends eight data bits on its MOSI line. At the same time it receives eight data bits from the slave on the MISO line.
    3. The master pulls SSEL up to indicate that the transfer is over.

    If the master had more than one 8-bits data to send/receive, it could keep sending/receiving and de-assert SSEL only when it is done.

    Multiple slaves

    An SPI master can communicate with multiples slaves in two ways: by connecting most signals in parallel and adding SSEL lines, or by chaining the slaves.

    With the multiple SSEL lines technique, only one SSEL line is activated at a time, and slaves that are not selected must not drive the MISO line.

    How fast is it?

    SPI can easily achieve a few Mbps (mega-bits-per-seconds). That means it can be used for uncompressed audio, or compressed video.

    Links
    YKJIAO
  • 相关阅读:
    Postman教程大全
    Java关键字(一)——instanceof
    RocketMQ(1)-架构原理----通用MQ知识点
    CAP理论的理解
    Buy the Ticket HDU
    高斯消元求多元一次方程(讲解+板子)
    P3709 大爷的字符串题 莫队
    P4074 [WC2013]糖果公园 树上莫队带修改
    java的静态代码块和类变量的隐式覆盖
    SP10707 COT2
  • 原文地址:https://www.cnblogs.com/ajiaoa/p/12773009.html
Copyright © 2011-2022 走看看